Was ist die StarterBox? Wann brauche ich die StarterBox? Was mache ich, wenn etwas nicht funktioniert? Bitte lesen Sie sich das aufmerksam durch. Letztere erhalten Sie gesondert per Post. Verlegen Sie Kabel so, dass niemand darauf treten oder stolpern kann.
|Published (Last):||10 February 2009|
|PDF File Size:||10.96 Mb|
|ePub File Size:||10.97 Mb|
|Price:||Free* [*Free Regsitration Required]|
Nikok This standard is also available to be included in Standards Subscriptions. If the flux is Bcompliant, the compliance statement is typically prominent on the front of the label. Standards Subscriptions from ANSI provides a money-saving, multi-user solution for accessing standards. For potable water systems, only lead-free solders shall be used, some of which are described in Specification B The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not axtm standard.
Historical Version s — view previous versions of standard. As the voice of the U. Choice of solder will depend atm the type of application and on local codes. Standards Subsctiption may be the perfect solution. Use Only Water-based Flux When Soldering Copper Pipe The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
This standard is not included in any packages. For potable water systems, b lead-free solders shall be used, some of which are described in Specification B For hazard statements, see the warning statements in 6.
CLC Newsletter Spring It is also used in the assembly of nonpressurized systems such as drainage, waste, and vent. It is also used in the assembly of nonpressurized systems such as drainage, waste, and vent. If the document is revised or amended, you will be notified by email. Choice of solder will depend upon the type of application and on local codes. Applicable specifications are listed in Appendix X1. For hazard statements, see the warning statements in 6. Referenced Documents purchase separately The documents listed below b referenced within the subject standard but are not provided as part of the standard.
Also, joints that are cleaned and fluxed one day should be soldered that same day. Already Subscribed to this document. Need more than one copy? Add to Alert PDF. We have no amendments or corrections for this standard. The results showed that solder joints made with b of the B fluxes were indistinguishable compared to the non-B fluxes, and were of better quality. Please first log in with a verified email before subscribing to alerts. Link to Active This link will always route to the current Active version of the standard.
Please first verify your email before subscribing to alerts. Not only can this cause pipe failure, but it also can increase the copper concentration in drinking water above the national water quality standards, which may cause gastrointestinal upset and affect taste and odor. Subscription pricing is determined by: Installation practices includes thoroughly flushing newly soldered pipe and sink ashm at a robust velocity for at least 30 minutes.
B fluxes are affected by water and moisture as well as heat; therefore, it is recommended that flux containers remain closed when not in use so rainwater, water on the job site, or water absorbed from humidity does not dilute the flux and reduce its effectiveness.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Most Related.
ASTM B828 PDF
FRITZ!Box 7590 Service - Wissensdatenbank