E3S-AD63 OMRON PDF

Sign in to check out Check out as guest. If you have any change for address, please inform us in paypal note or send an email before shipping. Thank you for your feedback. Resume making your offerif the page does not update immediately. Shop Disconnect Switches Isolators. Buyers may be subject to additional charges for customs clearance.

Author:Vim Musho
Country:Belgium
Language:English (Spanish)
Genre:Career
Published (Last):2 February 2012
Pages:143
PDF File Size:10.76 Mb
ePub File Size:20.83 Mb
ISBN:658-4-31386-868-3
Downloads:74485
Price:Free* [*Free Regsitration Required]
Uploader:Kazrazilkree



Page Values in brackets are the minimum required distance between the Sensor and Reflector. Mount the Sensor with care. Pre-wired cable: Approx Approx. This means the sensitivity can be adjusted on only a single Photoelectric Sensor, and then the adjusters on the other Photoelectric Sensors can be set to the same scale position. There is no need to adjust the sensitivity of each Photoelectric Sensor individually.

Mounting Bracket Provided The direction of the optical axis coincides with the machine axis of the E3S-A when the mounting screw is inserted into the lock hole of the Mounting Bracket. If the mounting surface and the screw hole are correctly aligned toward the sensing Photoelectric Sensor will not function.

Operating Mode Selection As shown in the following illustration, the E3S-A has an operating mode selector on the panel where the Receiver connector is located. Insulator diameter: 5. Operation mode selector switch 1. Mounting Holes Two, M3 holes 20 4-dia.

Light indicator red Sensitivity Operation mode adjuster selector switch white Stainless 7. Through-beam Model 6. E3S-A 6. Performance, however, will depend on conditions. N max. Work Required for Unconnected Leads Unused leads for self-diagnosis outputs or other special functions should be cut and wrapped with insulating tape to prevent contact with other terminals.

After countermeasure Insert an insulator. Result The testing conditions of the standard cable and robot cable are different. Refer to the values in the above table to check bend-resistant performance under actual working conditions.

Move the Photoelectric Sensor both vertically and horizontally and set it in the center of the range in which the operation indicator is lit or not lit. For the E3S-C, the optical axis and the mechanical axis are the same, so the optical axis can be easily adjusted by aligning the mechanical axis The lens and case of the Photoelectric Sensor are primarily made of plastic.

Dirt should be gently wiped off with a dry cloth. Do not use thinner or other organic solvents. The lens, however, is plastic. Please read and understand this catalog before purchasing the products. Related keywords.

LINGUAPHONE THAI PDF

Omron E3S-AD63 Manuals

.

AS BRUMAS DE AVALON VOL 4 PDF

E3S-AD63 OMRON PDF

.

GUBNER SOLUTIONS PDF

E3S-AT61-D Omron, E3S-AT61-D Datasheet

.

Related Articles