This section explains the steps to run the setup. Before you can run the Introscope agent setup, the setup wizard for the managed system must have been executed. Your screen will look similar to the image below: 5. Check the Enterprise Manager Settings at the top of the screen. These are the connection parameters that will be used by the agent to connect to the Enterprise Manager.
|Published (Last):||20 June 2008|
|PDF File Size:||16.55 Mb|
|ePub File Size:||19.59 Mb|
|Price:||Free* [*Free Regsitration Required]|
This section explains the steps to run the setup. Before you can run the Introscope agent setup, the setup wizard for the managed system must have been executed. Your screen will look similar to the image below: 5. Check the Enterprise Manager Settings at the top of the screen.
These are the connection parameters that will be used by the agent to connect to the Enterprise Manager. In the pane Introscope Agent Setttings, select the system that you want to instrument with the agent. This will display the current status of the agent setup. To initially setup or update the agents, click Setup Introscope Agent …. This will open the setup dialog as shown below. Select the desired agent version by default only one available and choose the profile.
Next, check the desired instrumentation areas, and, in the case of AIX, review the AIX settings to match your environment J9 or classic mode. Finally, hit Apply to perform the necessary changes in the agent configuration. Agent config files will be adapted, an Autoprobe connector will be created if necessary, and the Java VM parameters will be set as required for the managed system.
For Netweaver 7. Use the Configtool to set the parameters as described. If the setup was successful, restart the managed system at your convenience, e. After the restart, the agent will be active and should show up in the Introscope UIs. Note: — If we configure the wily agent manually we need to download the. SAR file else we want to go for the automatic method i.
SCS for the same. SAR file in this folder only i. After extracting a folder wily is created with contains many files. In the above screenshot it is shown wily folder is created in ccms after extracting the. SAR file If we go into the wily folder we can see the some new foldersfolders. So we need to change 2 parameters in this file to make it connect to the Central System Solman Below are the two parameters we need to modify.
Default is Now we have located the 1st parameter mentioned above from the IntroscopeAgent Profile As shown below the value of the profile is localhost. We need to change it. So we are changing it via winscp or vi editor and save the file.
The option —Xbootclasspath disappears. No connector. We need to use the CreateAutoProbeConnector. Refer to the below screenshot:- Now, we need to create the Autoprobe connector by this tool. We need to run the following command:- java -jar CreateAutoProbeConnector.
So executing the command will result in the below shown output:- Below file will be created:- Activating the Agent: Set Java VM Parameters Now to activate the agent we need to specify 3 parameters in the config tool and restart the server.
The 3 parameters are:- -Dcom. The 1st profile specifies the IntroscopeAgent. Since IntroscopeAgent. The 2nd Profile specifies the Agent Name. Config Tool We need to set the above parameters in theconfig tool. It will also work if we restart the Java only from smicm or restart the server0 process from jcmon.
Since we are adding parameters to server0. Note:- Before restarting the server there is another activity to be done. Refer the below screenshot
CA Introscope integration to SAP FRUN
Introscope Wily Agent Installation